PERFMASTER FRICTION

Frequently Asked Questions:
Please refer to the following if you have any further questions please send us an email at techsupport@countmachinery.com

POWER DOES NOT TURN ON:

1. Check Fuse on rear panel.
2. Check outlet.

• FEED TABLE NOT FEEDING CORRECTLY(DOUBLE SHEETS:

1. Clean feed wheel rollers.
2. Bent or worn parts on the paper caliper.
3. Adjust the Paper Retard Spring.

• SHEETS NOT FEEDING STRAIGHT:

1. Clean ALL rubber rollers.
2. Align feed table rails.
3. Check forwarding rollers. Make sure the set screws are snug.
4. Check burr wheels. Make sure they turn freely. Lubricate with WD-40 occasionally.

• NOT REGISTERING:

1. Clean rollers.
2. Check pressure on burr wheels above main roller. If these are not down firmly, your registration will be off.

• PERFORATION IS NOT CLEAN OR CUTS SHEET:

1. Blade is worn. Pull perf assembly and inspect tips of blade. Should be cupped in a u-shape. If they appear flat, replace blade. See "Replacing a Perf Blade."

• PERF IS NOT STRAIGHT:

1. Check for equal pressure on all gripper wheels and that none are hanging up.
2. Make sure forwarding rollers set screws are set and in position.
3. Check feed rails for pinching
4. Realign feed rails.